| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In Eclipse ThreadX versions 6.0.1 through 6.5.2.202603, the PendSV handler of the Cortex-M module ports saves a preempted user-mode module thread's registers in privileged mode at addresses taken from the thread's stack pointer, without checking that pointer against the thread's stack. A user-mode, memory-protected module can thereby write up to nine words, eight of its choosing, or 25 with floating-point state, into memory immediately below any region it may write, and read back what is stored there. |
| In Modem, there is a possible out of bounds write due to an incorrect bounds check. This could lead to remote denial of service, if a UE has connected to a rogue base station controlled by the attacker, with no additional execution privileges needed. User interaction is not needed for exploitation. Patch ID: MOLY01777997; Issue ID: MSV-8905. |
| In Modem, there is a possible out of bounds write due to a missing bounds check. This could lead to local escalation of privilege if a malicious actor has already obtained the System privilege. User interaction is not needed for exploitation. Patch ID: MOLY01320076; Issue ID: MSV-6889. |
| The Bluetooth HCI USB transport class of the new USB device stack, subsys/usb/device_next/class/bt_hci.c, copies every controller-to-host HCI packet into a USB transfer buffer before enqueuing it on an endpoint. bt_hci_tx_sync_in() allocated that buffer from bt_hci_ep_pool, a fixed pool whose slots are only USBD_MAX_BULK_MPS bytes (64 on full-speed-only builds), and then performed net_buf_add_mem(buf, bt_buf->data, bt_buf->len) with no length check. HCI event and ACL buffers are sized by CONFIG_BT_BUF_EVT_RX_SIZE and CONFIG_BT_BUF_ACL_RX_SIZE and can be far larger, so the copy runs past the end of the 64-byte slot into the adjacent slots and into whatever follows the statically allocated pool.
The device runs the local Bluetooth controller in raw HCI mode (CONFIG_BT_HCI_RAW), so the oversized packets originate over the air. With the HCI buffer sizes recommended for full-featured controllers, an unauthenticated attacker within Bluetooth range can supply the overflowing bytes: a connected peer that negotiates Data Length Extension can send ACL fragments up to CONFIG_BT_CTLR_DATA_LENGTH_MAX bytes, and an attacker that merely broadcasts extended advertising data reaches the same path through LE Extended Advertising Report events, which the controller fragments only to CONFIG_BT_BUF_EVT_RX_SIZE. In the stock configuration the overflow is already reached without any radio traffic: the mandatory Read Supported Commands command-complete event is 70 bytes and overruns the 64-byte slot by six bytes on every host initialization.
Because net_buf_add_mem() validates tailroom only through an assertion unless CONFIG_NET_BUF_HARDENING is enabled, builds with CONFIG_ASSERT=n — the usual production setting — silently corrupt memory adjacent to the USB buffer pool with attacker-chosen contents, which on a target without memory protection between subsystems can lead to arbitrary code execution. Builds with assertions enabled fail the assertion instead and panic, giving a remotely triggerable denial of service. The fix introduces a separate bt_hci_tx_pool sized to MAX(BT_BUF_ACL_RX_SIZE, BT_BUF_EVT_RX_SIZE) for the controller-to-host direction while leaving the host-to-device pool at the endpoint packet size, which is already bounds-checked during reassembly. |
| libgphoto2 through 2.5.34 contains stack-based and heap-based buffer overflow vulnerabilities in jl2005c_init() that allow malicious USB devices to corrupt memory by supplying an unbounded allocation table entry count. Attackers can connect a spoofed Jeilin JL2005B/C/D camera reporting 1022 or more entries to overwrite the saved return address and heap data, potentially achieving code execution. |
| An out-of-bounds write issue was addressed with improved bounds checking. This issue is fixed in iOS 26.7.2 and iPadOS 26.7.2, iOS 27.2 and iPadOS 27.2, macOS Golden Gate 27.2, macOS Tahoe 26.7.2. Processing a maliciously crafted image may lead to unexpected app termination. |
| An unauthenticated buffer overflow vulnerability exists in the PAPI protocol of AOS-8. Successful exploitation could allow an unauthenticated remote attacker to disrupt the availability of the affected service on the controller, with a limited impact to its integrity. |
| An out-of-bounds write was addressed with improved input validation. This issue is fixed in iOS 26.7.2 and iPadOS 26.7.2, iOS 27.2 and iPadOS 27.2, macOS Golden Gate 27.2, macOS Sequoia 15.8.2, macOS Tahoe 26.7.2, visionOS 27.2. An app may be able to cause unexpected system termination or corrupt process memory. |
| An out-of-bounds access issue was addressed with improved bounds checking. This issue is fixed in iOS 26.7 and iPadOS 26.7, iOS 27.2 and iPadOS 27.2, macOS Golden Gate 27.2, macOS Sequoia 15.8.2, macOS Tahoe 26.7.2, tvOS 27.2, visionOS 27.2. Processing a maliciously crafted media file may lead to unexpected app termination or corrupt process memory. |
| An out-of-bounds write issue was addressed with improved bounds checking. This issue is fixed in iOS 26.7.2 and iPadOS 26.7.2, iOS 27.2 and iPadOS 27.2, macOS Golden Gate 27.2, macOS Sequoia 15.8.2, macOS Tahoe 26.7.2, visionOS 27.2. Processing a maliciously crafted image may lead to unexpected app termination. |
| Netpbm before 10.86.51, 11.x before 11.02.30, and 11.03 before 11.15.08 contains a heap buffer overflow in xpmtoppm caused by an unvalidated characters-per-pixel value in the XPM header. Attackers can supply a crafted XPM file with characters-per-pixel greater than 3 to overrun fixed 3-byte colorName hash entries, causing crashes or potentially code execution. |
| The RTIO streaming completion callback adxl345_process_fifo_samples_cb() in drivers/sensor/adi/adxl345/adxl345_stream.c clamps the amount of FIFO data it will report (read_len = MIN(fifo_bytes, buf_avail)) to the space actually returned by rtio_sqe_rx_buf(), but then queues one 6-byte bus read per hardware FIFO entry at consecutive offsets from read_buf, bounded by the device-reported entry count rather than by the clamp. When the allocated buffer is smaller than a full batch, the driver writes up to 186 bytes past the end of the allocation; a companion defect left data->fifo_total_bytes un-reset at batch start, so an aborted or errored chain could leave a stale write offset that pushes the next batch's writes out of bounds as well.
A short buffer is an expected, first-class outcome of the RTIO allocator: rtio_block_pool_alloc() walks the requested size down one block at a time until a contiguous run is available, and the driver only demands sizeof(struct adxl345_fifo_data) + 6 bytes as its minimum. Any streaming configuration whose mempool block granularity is smaller than a full FIFO batch (204 bytes) — for example the sensor shell's RTIO_DEFINE_WITH_MEMPOOL(sensor_read_rtio, 8, 8, 32, 64, 4) used by sensor stream <dev> on fifo_wm incl, or the 16-byte-block streaming example in the documentation — takes this path whenever the pool is fragmented or the consuming thread falls behind.
The out-of-bounds writes are performed by the I2C/SPI RTIO backend (DMA on many SoCs) into the shared RTIO block pool, corrupting neighbouring live buffers or, for a pool smaller than one batch, memory beyond the pool itself. The written bytes are accelerometer samples and the destination follows the allocation, so there is no controllable corruption primitive: the realistic impact is silent corruption of other RTIO consumers' data or a crash. Reaching it requires a board with an interrupt-wired ADXL345 built with CONFIG_ADXL345_STREAM, plus buffer-pool starvation, which a co-resident local workload can induce but which also occurs spontaneously under load; there is no network, USB or radio path to this code. |
| In the Linux kernel, the following vulnerability has been resolved:
spi: imx: fix slab corruption from undersized DMA bounce buffers
Since commit faa8e404ad8e ("spi: imx: support dynamic burst length for
ECSPI DMA mode"), the driver allocates its private DMA TX/RX buffers
with kzalloc(dma_len), where dma_len is only rounded up to 4 bytes, but
maps, syncs and unmaps them with DMA_CACHE_ALIGNED_LEN(dma_len), i.e.
rounded up to the cache line size. As a result, the DMA API operates on
memory beyond the end of the allocation.
This was observed on a custom i.MX8MP platform with an mcp251xfd CAN
controller under heavy RPMSG load, as a series of refcount_t warnings
triggered from rpmsg_recv_done() in virtio_rpmsg_bus:
refcount_t: addition on 0; use-after-free.
refcount_t: underflow; use-after-free.
refcount_t: saturated; leaking memory.
Leading finally to an "Unable to handle kernel paging request" oops.
Reproducing this problem took between 30 minutes and roughly 30 hours
under the same workload.
Hardware watchpoints on the refcount of a struct rpmsg_endpoint showed
it was overwritten from 2 to 1 by __pi_memcpy_generic() in the
irq/155-spi2.0 thread. Additionally it was found that a "normal"
rpmsg_recv_done() took 11µs +/-2µs from its kref_get to kref_put. In
the error case the same sequence took about 215µs +/-10µs. Based on
this, an LLM was used to identify the size mismatch fixed here.
Allocate the buffers with DMA_CACHE_ALIGNED_LEN(dma_len) so they cover
the full mapped length, and use the same length for
dma_sync_single_for_cpu() to stay consistent with map and unmap.
With this patch applied, the same workload ran for more than 200 hours
without the problem reproducing. |
| In the Linux kernel, the following vulnerability has been resolved:
tracing: Keep the predicate limit separate from program capacity
predicate_parse() adds two to nr_preds to reserve the terminal TRUE
and FALSE entries. It also uses that increased value as the limit for
parsed predicates. If the initial count is smaller than the number
actually parsed, the program can fill the allocation and subsequent
accesses can go past its end.
Keep nr_preds as the predicate limit and use a separate value for the
allocation size. This leaves space for both terminal entries and a
zeroed entry when parsing stops at the limit. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix heap overflow in cifs_do_set_acl()
cifs_set_acl() validates ACL size using posix_acl_xattr_size():
4 + (count * 8) // 4-byte header + 8 bytes per ACE
cifs_do_set_acl() then calls posix_acl_to_cifs() to write the CIFS
wire format into the same buffer:
6 + (count * 10) // 6-byte header + 10 bytes per ACE
An ACL that passes the xattr-based check in cifs_set_acl() can
overflow the heap when posix_acl_to_cifs() writes the larger CIFS
format.
Validate the CIFS format size against the remaining buffer space and
USHRT_MAX before converting--data_count is __u16, so sizes above
USHRT_MAX truncate the on-wire packet length, causing the server to
apply a partial ACL. Replace MaxDataCount = 1000 with
min(CIFSMaxBufSize, USHRT_MAX). |
| In the Linux kernel, the following vulnerability has been resolved:
tracing: Check operator stack capacity before pushing
predicate_parse() uses the first operator stack entry before processing
any opening parentheses. A push then increments top before writing.
The existing check still permits that write when top already points to
the last allocated entry, which can access beyond the operator stack.
Reject the push when top reaches the last allocated entry. |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs: fix incorrect MFT record pointer passed to ntfs_attr_record_resize
ntfs_new_attr_flags() passes the wrong MFT record to ntfs_attr_record_resize().
When the attribute is in an extent record, ctx->mrec points to the extent
but the function receives the base record pointer m, causing incorrect
size calculations in memmove.
Fix by passing ctx->mrec (the actual MFT record containing the attribute)
instead of m (the base MFT record) to ntfs_attr_record_resize(). |
| DevilutionX 1.4.0 through 1.5.5 contains a heap buffer overflow vulnerability in the bundled libmpq libmpq__archive_dup routine when opening crafted MPQ archives. Attackers can supply an MPQ archive whose block table count exceeds its hash table count, causing memcpy to overflow the heap during startup and crash the game. |
| FLTK through 1.4.5 contains an integer overflow vulnerability in Fl_BMP_Image::load_bmp_() that causes undersized pixel buffer allocation from file-supplied width and height. Attackers can supply a crafted BMP or ICO file with large dimensions so row decoding writes file-derived data past the heap buffer, corrupting the application heap. |
| A flaw was found in dnsmasq. After a reduction of internal domain-name buffer sizes, the DNSSEC validator can write a few bytes past a name buffer when converting names to and from DNS wire format. An attacker who can cause the server to validate a crafted DNSSEC response may overwrite a small amount of adjacent heap metadata. DNSSEC support is not compiled in by default and must also be enabled at runtime. |
