| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A potential security vulnerability has been identified in certain HP PC products using AMI BIOS, which might allow arbitrary code execution. AMI has released firmware updates to mitigate this vulnerability. |
| Nokia Single RAN baseband software versions earlier than 24R1-SR 2.1 MP contain a SOAP message input validation flaw, which in theory could potentially be used for causing resource exhaustion in the Single RAN baseband OAM service.
No practical exploit has been detected for this flaw. However, the issue has been corrected starting from release 24R1-SR 2.1 MP by adding sufficient input validation for received SOAP requests, effectively mitigating the reported issue. |
| Sending a crafted SOAP "set" operation message within the Mobile Network Operator (MNO) internal Radio Access Network (RAN) management network can cause Nokia Single RAN baseband OAM service component restart with software versions earlier than release 24R1-SR 1.0 MP. This issue has been corrected to release 24R1-SR 1.0 MP and later.
The OAM service component restarts automatically after the stack overflow without causing a base station restart or network service degradation, and without leaving any permanent impact on the Nokia Single RAN baseband OAM service. |
| An out-of-bounds read vulnerability exists in the cv_send_blockdata
functionality of Dell ControlVault3 prior to 5.15.10.14 and Dell ControlVault3 Plus prior to 6.2.26.36. A specially crafted
ControlVault API call can lead to an information leak. An attacker can
issue an API call to trigger this vulnerability. |
| There is a potential OOB Write vulnerability in the gen_prov_start function in pb_adv.c. The full length of the received data is copied into the link.rx.buf receiver buffer without any validation on the data size. |
| A security issue exists due to improper handling of CIP Class 32’s request when a module is inhibited on the 5094-IY8 device. It causes the module to enter a fault state with the Module LED flashing red. Upon un-inhibiting, the module returns a connection fault (Code 16#0010), and the module cannot recover without a power cycle. |
| Improper access control on the NetScaler Management Interface in NetScaler ADC and NetScaler Gateway when an attacker can get access to the appliance NSIP, Cluster Management IP or local GSLB Site IP or SNIP with Management Access |
| A vulnerability was found in D-Link DIR-513 up to 20190831. It has been declared as critical. This vulnerability affects the function formSetWanDhcpplus of the file /goform/formSetWanDhcpplus. The manipulation of the argument curTime leads to buffer overflow. The attack can be initiated remotely. This vulnerability only affects products that are no longer supported by the maintainer. |
| Exporting a TPM based RSA key larger than 2048 bits from the TPM could overrun a stack buffer if the default `MAX_RSA_KEY_BITS=2048` is used. If your TPM 2.0 module supports RSA key sizes larger than 2048 bit and your applications supports creating or importing an RSA private or public key larger than 2048 bits and your application calls `wolfTPM2_RsaKey_TpmToWolf` on that key, then a stack buffer could be overrun. If the `MAX_RSA_KEY_BITS` build-time macro is set correctly (RSA bits match what TPM hardware is capable of) for the hardware target, then a stack overrun is not possible. |
| Supermicro BMC Insyde SMASH shell program has a stacked-based overflow vulnerability |
| The <redacted>.so library, which is used by <redacted>, is
vulnerable to a buffer overflow in the code that handles the deletion
of certificates. This buffer overflow can be triggered by providing a
long file path to the <redacted> action of the <redacted>.exe CGI binary or
to the <redacted>.sh CGI script. This binary or script will write this
file path to <redacted>, which is then
read by <redacted>.so
This issue affects Iocharger firmware for AC models before version 24120701.
Likelihood: Moderate – An attacker will have to find this exploit by
either obtaining the binaries involved in this vulnerability, or by trial
and error. Furthermore, the attacker will need a (low privilege)
account to gain access to the <redacted>.exe CGI binary or <redacted>.sh
script to trigger the vulnerability, or convince a user with such access
send an HTTP request that triggers it.
Impact: High – The <redacted> process, which we assume is
responsible for OCPP communication, will keep crashing after
performing the exploit. This happens because the buffer overflow
causes the process to segfault before
<redacted> is removed. This means that,
even though <redacted> is automatically restarted, it will crash
again as soon as it tries to parse the text file.
CVSS clarification. The attack can be executed over any network connection the station is listening to and serves the web interface (AV:N), and there are no additional security measure sin place that need to be circumvented (AC:L), the attack does not rely on preconditions (AT:N). The attack does require authentication, but the level of authentication is irrelevant (PR:L), it does not require user interaction (UI:N). The attack leads to reducred availability of the device (VC:N/VI:N/VA:H). THere is not impact on subsequent systems. (SC:N/SI:N/SA:N). Alltough this device is an EV charger handing significant amounts of power, we do not forsee a safety impact. The attack can be automated (AU:Y). Because the DoS condition is written to disk persistantly, it cannot be recovered by the user (R:I). |
| There are many buffer overflow vulnerabilities present in several CGI binaries of the charging station.This issue affects Iocharger firmware for AC model chargers beforeversion 24120701.
Likelihood: High – Given the prevalence of these buffer overflows, and the clear error message of the web server, an attacker is very likely to be able to find these vulnerabilities.
Impact: Low – Usually, overflowing one of these buffers just causes a segmentation fault of the CGI binary, which causes the web server to return a 502 Bad Gateway error. However the webserver itself is not affected, and no DoS can be achieved. Abusing these buffer overflows in a meaningful way requires highly technical knowledge, especially since ASLR also seems to be enabled on the charging station. However, a skilled attacker might be able to use one of these buffer overflows to obtain remote code execution.
CVSS clarification. The attack can be executed over any network connection the station is listening to and serves the web interface (AV:N), and there are no additional security measure sin place that need to be circumvented (AC:L), the attack does not rely on preconditions (AT:N). The attack does require authentication, but the level of authentication is irrelevant (PR:L), it does not require user interaction (UI:N). The attack has a small impact on the availability of the device (VC:N/VI:N/VA:L). There is no impact on subsequent systems. (SC:N/SI:N/SA:N). While this device is an EV charger handing significant amounts of power, we do not expect this vulnerability to have a safety impact. The attack can be automated (AU:Y). |
| Incorrect Access Control in GStreamer RTSP server 1.25.0 in gst-rtsp-server/rtsp-media.c allows remote attackers to cause a denial of service via a series of specially crafted hexstream requests. |
| A code execution vulnerability exists in the Xiaomi Game center application product. The vulnerability is caused by improper input validation and can be exploited by attackers to execute malicious code. |
| The HTTPD binary in multiple ZTE routers has a stack-based buffer overflow vulnerability in rsa_decrypt function. This function is an API wrapper for LUA to decrypt RSA encrypted ciphertext, the decrypted data is stored on the stack without checking its length. An authenticated attacker can get RCE as root by exploiting this vulnerability. |
| The HTTPD binary in multiple ZTE routers has a stack-based buffer overflow vulnerability in webPrivateDecrypt function. This function is responsible for decrypting RSA encrypted ciphertext, the encrypted data is supplied base64 encoded. The decoded ciphertext is stored on the stack without checking its length. An unauthenticated attacker can get RCE as root by exploiting this vulnerability. |
| The HTTPD binary in multiple ZTE routers has a stack-based buffer overflow vulnerability in check_data_integrity function. This function is responsible for validating the checksum of data in post request. The checksum is sent encrypted in the request, the function decrypts it and stores the checksum on the stack without validating it. An unauthenticated attacker can get RCE as root by exploiting this vulnerability. |
| A potential buffer overflow vulnerability was reported in some Lenovo ThinkSystem and ThinkStation products that could allow a local attacker with elevated privileges to execute arbitrary code. |
| WithSecure Atlant (formerly F-Secure Atlant) 1.0.35-1 allows a remote Denial of Service because of memory corruption during scanning of a PE32 file. |
| A vulnerability classified as critical has been found in GL.iNet GL-A1300 Slate Plus, GL-AR300M16 Shadow, GL-AR300M Shadow, GL-AR750 Creta, GL-AR750S-EXT Slate, GL-AX1800 Flint, GL-AXT1800 Slate AX, GL-B1300 Convexa-B, GL-B3000 Marble, GL-BE3600 Slate 7, GL-E750, GL-E750V2 Mudi, GL-MT300N-V2 Mango, GL-MT1300 Beryl, GL-MT2500 Brume 2, GL-MT3000 Beryl AX, GL-MT6000 Flint 2, GL-SFT1200 Opal, GL-X300B Collie, GL-X750 Spitz, GL-X3000 Spitz AX, GL-XE300 Puli and GL-XE3000 Puli AX 4.x. Affected is an unknown function of the file plugins.so of the component RPC Handler. The manipulation leads to buffer overflow. It is recommended to upgrade the affected component. |
