| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| HashiCorp go-slug 0.4.0 through 0.18.2 could allow a local attacker to bypass .terraformignore exclusions and cause sensitive files to be included in Terraform slug uploads due to improper handling of Unicode normalization during path matching. |
| IBM Verify Identity Access Advanced Access Control may be vulnerable to an information disclosure attack. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_event: validate LE Set CIG Parameters response
The Command Complete dispatch validates only the fixed part of the LE Set
CIG Parameters response. After that part is pulled from the skb,
hci_cc_le_set_cig_params() trusts num_handles and reads each entry in the
trailing handle array.
Matching num_handles against the command's num_cis does not guarantee
that the response contains the advertised handles. A truncated response
from a malfunctioning controller can therefore make the handler read
beyond the skb data.
Validate that the remaining skb data contains all advertised handles.
Include this in the existing response validation so malformed responses
also follow the established CIG failure handling. |
| In the Linux kernel, the following vulnerability has been resolved:
nfc: st21nfca: validate ATR_REQ length against the received frame
st21nfca_tm_recv_atr_req() checks that the received ATR_REQ frame is at
least ST21NFCA_ATR_REQ_MIN_SIZE and that the self-declared atr_req->length
is at least sizeof(struct st21nfca_atr_req), but never checks that
atr_req->length does not exceed the actual received length (skb->len).
st21nfca_tm_send_atr_res() then trusts the declared length:
gb_len = atr_req->length - sizeof(struct st21nfca_atr_req);
...
memcpy(atr_res->gbi, atr_req->gbi, gb_len);
so an RF peer that sends a short frame but sets atr_req->length larger
than the frame makes gb_len exceed the general bytes actually present,
and the memcpy reads out of bounds past the received skb. Those bytes are
placed in the ATR_RES and sent back to the peer (kernel-memory disclosure
to a proximity attacker); a larger declared length is an out-of-bounds
read (DoS).
Reject frames whose declared length exceeds the received length. The
adjacent nfc_tm_activated() path in the same function already derives its
general-bytes length from skb->len rather than the declared field.
Found by 0sec (https://0sec.ai) using automated source analysis; the
missing bound is evident from source. Compile-tested. |
| IBM Db2 Mirror for i 7.4, 7.5, and 7.6 could allow a remote attacker to cause a denial of service due to an out-of-bounds read. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a local attacker to cause a denial of service due to a stack-based buffer overflow. |
| crmne/ruby_llm at commit fa6f279847d6d7027814539d9c0dfc3bbdfd2a83 contains a polynomial-time regular expression denial-of-service condition in RubyLLM::Utils.underscore on Ruby 3.1.x. A very long crafted class, agent, or tool name can cause excessive CPU consumption and a denial of service. |
| fast-uri serializes the port component of a URI without validating it. When recomposing the authority, the userinfo and host components are escaped but the port is concatenated verbatim, so a port value that is not a sequence of digits can inject authority delimiters, demoting the intended host to userinfo and pointing the authority at an attacker-controlled host. Both fast-uri and Node's URL read the result back as the attacker's host with no error, so re-validating the built URI does not catch it. This affects applications that build URIs from parts and assign untrusted data to the port component through the serialize, normalize, or equal functions in their object forms. The issue affects fast-uri versions before 2.4.6, from 3.0.0 before 3.1.7, and from 4.0.0 before 4.1.4. It is fixed in 2.4.6, 3.1.7, and 4.1.4, where recomposeAuthority rejects any port that is not a digit sequence per RFC 3986. |
| A vulnerability was detected in valkey-io valkey up to 9.5.4/9.1.0. Affected by this vulnerability is the function createSlotImportJob of the file src/cluster_migrateslots.c of the component Slot Migration. The manipulation of the argument job_name results in out-of-bounds read. The attack can be executed remotely. The exploit is now public and may be used. Upgrading to version 9.0.5 and 9.1.1 addresses this issue. The patch is identified as f4dc3ca09eb650c2fe14060090a41c524eca803f. Upgrading the affected component is advised. |
| fastify versions before 5.12.2 implement the case-insensitive nature of HTTP header names by lowercasing names in a route's header schema before compiling it, but the transformation is incomplete: it lowercases the properties keys and the root-level required array, and does not lowercase the trigger and dependent names inside the JSON Schema Draft 7 dependencies keyword. Because Node stores request header names in lowercase, a canonical-case dependency such as requiring an authentication header whenever a privileged-mode header is present never matches, and the presence assertion is silently skipped. An unauthenticated remote client can therefore send the header that activates a privileged branch while omitting the header the dependency was meant to require, bypassing the conditional check. Users should upgrade to fastify 5.12.2 or later. |
| fast-uri accepts a host that contains an unbalanced or misplaced authority bracket without reporting an error. A host that starts with an opening bracket but does not end with a closing bracket is neither validated as an IP literal nor canonicalized as a domain name, so parse() returns it as the host with error undefined, while Node's URL and the HTTP clients built on it resolve the same string to a different host. An application that reads the parsed host to make a host decision, such as an SSRF denylist, a redirect allowlist, or proxy routing, and then passes the original URL to an HTTP client evaluates its policy against a string that is not the host the request reaches. The same host is carried through normalize, equal, and resolve. This affects fast-uri versions 2.4.5, 3.1.6, and 4.1.3, and is fixed in 2.4.6, 3.1.7, and 4.1.4, where parse() reports a malformed host for any host that contains a bracket but is not a valid IPv6 literal. |
| In the Linux kernel, the following vulnerability has been resolved:
xfs: fix exchmaps reservation limit check
xfs_exchmaps_estimate_overhead() adds the bmbt and rmapbt
overhead to a local resblks variable, but the final UINT_MAX
check still tests req->resblks. That is the reservation value
from before the overhead was added.
The computed value is stored back in req->resblks and later passed
to xfs_trans_alloc(), whose block reservation argument is unsigned
int. Check the computed reservation so the existing limit applies
to the value that will be used. |
| In the Linux kernel, the following vulnerability has been resolved:
hfs/hfsplus: fix u32 overflow in check_and_correct_requested_length
check_and_correct_requested_length() compares (off + len) against
node_size using u32 arithmetic. When the caller passes a large len
value (e.g. from an underflowed subtraction in hfs_brec_remove()),
off + len can wrap past 2^32 and produce a small result, causing the
bounds check to pass when it should fail.
For example, with off=14 and len=0xFFFFFFF2 (underflowed from
data_off - keyoffset - size in hfs_brec_remove), off + len wraps to 6,
which is less than a typical node_size of 512, so the check passes and
the subsequent memmove reads ~4GB past the node buffer.
Fix this by widening the addition to u64 before comparing against
node_size. This prevents the u32 wrap while keeping the logic
straightforward. |
| ** UNSUPPORTED WHEN ASSIGNED ** Stack-based Buffer Overflow vulnerability in Apache Lucy.
This issue affects Apache Lucy: all versions.
As this project is retired, we do not plan to release a version that fixes this issue. Users are recommended to find an alternative or restrict access to the instance to trusted users.
Lucy is now maintained outside of the ASF
at https://github.com/lucysearch . This issue has been fixed in 0.8.0 there.
NOTE: This vulnerability only affects products that are no longer supported by the maintainer. |
| pymonocypher uses cython to wrap the Monocypher C library. Prior to version 4.0.2.8, the argon2i_32 implementation does not check the nb_blocks size. If the caller does not provide a sufficiently large buffer based on the API contract, then argon2i_32 will write past the end of the buffer and possibly corrupt the heap. This issue has been patched in version 4.0.2.8. |
| In the Linux kernel, the following vulnerability has been resolved:
io_uring/io-wq: re-check IO_WQ_BIT_EXIT for each linked work item
commit 10dc95939817 ("io_uring/io-wq: check IO_WQ_BIT_EXIT inside work
run loop") fixed the obvious case where io_worker_handle_work() took one
exit-bit snapshot before draining pending work, but the fix stops one
level too early.
io_worker_handle_work() now re-checks IO_WQ_BIT_EXIT in its outer work
run loop, yet it still snapshots that bit once before processing a whole
dependent linked-work chain. If io_wq_exit_start() sets IO_WQ_BIT_EXIT
after the first linked item has started, the remaining linked items can
still reuse stale do_kill = false, skip IO_WQ_WORK_CANCEL, and continue
running after exit has begun.
Move the check further inside, so it covers linked items too. Note: this
is a syzbot special as it loves setting up tons of slow linked work on
weird devices like msr that take forever to read, and immediately close
the ring. Exit then takes a long time. |
| No description is available for this CVE. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: btnxpuart: Fix out-of-bounds firmware read in nxp_recv_fw_req_v3()
During the v3 firmware download the controller sends a v3_data_req with a
32 bit offset and a 16 bit len. nxp_recv_fw_req_v3() checks only the lower
bound of the offset and then sends firmware from that offset.
nxpdev->fw_dnld_v3_offset = offset - nxpdev->fw_v3_offset_correction;
serdev_device_write_buf(nxpdev->serdev, nxpdev->fw->data +
nxpdev->fw_dnld_v3_offset, len);
Nothing checks that fw_dnld_v3_offset + len stays within nxpdev->fw->size,
so a controller that asks for an offset or length past the firmware image
makes the driver read past the end of nxpdev->fw->data and send that
memory back over UART.
nxp_recv_fw_req_v1() already bounds the same write. Add the equivalent
check to the v3 path, reject the request when it falls outside the firmware
image, and zero len on the error path so the fw_v3_prev_sent bookkeeping at
free_skb stays consistent. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: flowtable: IPIP tunnel hardware offload is not yet support
No driver supports for IPIP tunnels yet, give up early on setting up the
hardware offload for this scenario.
This patch adds a stub that can be enhanced to add more configuration
that are currently not supported. As of now, the offload work is
enqueued to the worker, then ignored if the hardware offload
configuration is not supported.
Check the NF_FLOW_HW flag to know if this entry was already tried once
to be offloaded so this is not retried on refresh when unsupported. Move
NF_FLOW_HW flag check to nf_flow_offload_add(). If this NF_FLOW_HW flag
is unset the _del and _stats variants are never called.
This can be updated later on to skip hardware offload work to be queued
in case hardware offload does not support it. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: ebtables: terminate table name before find_table_lock()
update_counters() and compat_update_counters() forward a user-supplied
32-byte table name to find_table_lock() without NUL-terminating it. On a
lookup miss, find_inlist_lock() calls try_then_request_module(..., "%s%s",
"ebtable_", name), and vsnprintf() reads past the name field and the
stack object until it hits a zero byte.
BUG: KASAN: stack-out-of-bounds in string (lib/vsprintf.c:648 lib/vsprintf.c:730)
Read of size 1 at addr ffff8880119dfb20 by task exploit/147
Call Trace:
...
string (lib/vsprintf.c:648 lib/vsprintf.c:730)
vsnprintf (lib/vsprintf.c:2945)
__request_module (kernel/module/kmod.c:150)
do_update_counters.isra.0 (net/bridge/netfilter/ebtables.c:371 net/bridge/netfilter/ebtables.c:380)
update_counters (net/bridge/netfilter/ebtables.c:1440)
do_ebt_set_ctl (net/bridge/netfilter/ebtables.c:2573)
nf_setsockopt (net/netfilter/nf_sockopt.c:101)
ip_setsockopt (net/ipv4/ip_sockglue.c:1424)
raw_setsockopt (net/ipv4/raw.c:847)
__sys_setsockopt (net/socket.c:2393)
...
compat_do_replace() shares the same unterminated name via
compat_copy_ebt_replace_from_user(); terminate it there too so all
find_table_lock() callers behave alike. The other callers already
terminate the name after the copy. |
